Rate sensitivity and deformation mechanism of semi-crystalline polymers during instrumented indentation

Instrumented indentation tests using both constant loading rate (CLR) and continuous stiffness measurement (CSM) operation modes were performed to investigate the deformation mechanism and their sensitivity to the deformation rate in semi-crystalline polymers through the quantitative analysis of load-depth loading and unloading curves. The strain rate was constant during the CSM tests, while the strain rate decreased with the increasing of loading time in CLR tests. The mechanical response mechanism of the semi-crystalline polymers to these tests was very complicated because of the combined effects of strain-hardening in the crystal phase and strain-softening in the amorphous phase. Results show that the loading index m reflects the strain-hardening or strain-softening response during indentation. When m > 2, the mechanical response was due to the strain-hardening, and when m < 2, the response was due to strain-softening. A method based on the measured contact hardness was proposed to obtain the unloading stiffness, and the other mechanical parameters could then be determined according to the unloading stiffness.     

Synthesis of 4H-chromenes by silver(Ⅰ)-catalyzed cycloaddition of ortho-quinone methides with N-allenamides

Chromenes represent an important class of six-membered heterocycles and have drawn tremendous attention in recent years. In this article, we report a convenient and practical synthesis of this heterocycle by a silver(I)-catalyzed cycloaddition reaction between in situ generated ortho-quinone methides and N-allenamides. Diverse 4H-chromenes were synthesized in good to excellent yields under very mild conditions.     

Devisable POM/Ni Foam Composite: Precisely Control Synthesis toward Enhanced Hydrogen Evolution Reaction at High pH

Polyoxometalates (POMs) are promising catalysts for the electrochemical hydrogen production from water owing to their high intrinsic catalytic activity and chemical tunability. However, poor electrical conductivity and easy detachment of the POMs from the electrode cause significant challenges under operating condition. Herein, a simple one-step hydrothermal method is reported to synthesize a series of Dexter–Silverton POM/Ni foam composites (denoted as Ni M -POM/Ni; M =Co, Zn, Mn), in which the stable linkage between the POM catalysts and the Ni foam electrodes lead to high activity for the hydrogen evolution reaction (HER). Among them, the highest HER performance can be observed in the NiCo-POM/Ni, featuring an overpotential of 64 mV (at 10 mA cm⁻², vs. reversible hydrogen electrode), and a Tafel slope of 75 mV dec⁻¹ in 1.0 m aqueous KOH. Moreover, the NiCo-POM/Ni catalyst showed a high faradaic efficiency ≈97 % for HER. Post-catalytic of NiCo-POM/Ni analyses showed virtually no mechanical or chemical degradation. The findings propose a facile and inexpensive method to design stable and effective POM-based catalysts for HER in alkaline water electrolysis.     

Selective Excitation of Band Extrema in Valley Photonic Crystals

Flexible control of building blocks of photonic crystals enables achieving desirable band structures. Exploration of photonic band extrema has brought many fantastic features to design artificial optical materials, such as Brillouin‐zone‐corner extrema for valley photonic materials and zone‐center extremum for zero‐index metamaterials. However, two such kinds of extrema are always found independently in different photonic crystals. In this work, a kind of valley photonic crystals possessing both zone‐center and zone‐corner band extrema almost at the same frequency is proposed. Inspired by antennas theory, a three‐antenna array (TAA) source is devoted to individually manipulate each extremum. The correlation coefficient is given to determine the coupling efficiency between the TAA source and extrema eigenmodes. By using a source with a high correlation coefficient, these extrema bulk states are selectively excited consistent with their eigenfields. Furthermore, three control cases are shown that multiple extrema points are simultaneously excited, in order to confirm the validity of the correlation coefficient. Finally, a potential application of a beam‐steering device is proposed through selective excitation of ternary extrema. This work develops binary valley states into ternary mix states, rendering more degrees of freedom for on‐chip optical information transport, particularly for beam steering and mode division multiplexing.     

A new endocytic model based on the co-rotational grid method

Endocytosis plays important roles in many cellular physiological processes, such as metabolism and immune. Many theoretical models have been proposed to study the endocytic process, but little has considered the tensile deformation of the membrane and the actin forces. In this paper, a new endocytic model is proposed based on the co-rotational grid method. Our model gives a direct estimation of the in-plane strain of the plasma membrane and provides a basis for the calculation of further scission process of the vesicle. The results fit well with experimental data in the literature. Moreover, it is suggested that the active forces of actin at the endocytic site is the main mechanism driving the invagination of the plasma membrane.     

GaInP/GaAs/Ge三结太阳电池不同能量质子辐照损伤模拟

以GaInP/GaAs/Ge三结太阳电池为研究对象,开展了能量为0.7, 1, 3, 5, 10 MeV的质子辐照损伤模拟研究,建立了三结太阳电池结构模型和不同能量质子辐照模型,获得了不同质子辐照条件下的I-V曲线,光谱响应曲线,结合已有实验结果验证了本文模拟结果,分析了三结太阳电池短路电流、开路电压、最大功率、光谱响应随质子能量的变化规律,利用不同辐照条件下三结太阳电池最大输出功率退化结果,拟合得到了三结太阳电池最大输出功率随位移损伤剂量的退化曲线.研究结果表明,质子辐照会在三结太阳电池中引入位移损伤缺陷,使得少数载流子扩散长度退化幅度随质子能量的减小而增大,从而导致三结太阳电池相关电学参数的退化随质子能量的减小而增大.相同辐照条件下,中电池光谱响应退化幅度远大于顶电池光谱响应退化幅度,中电池抗辐照性能较差,同时中电池长波范围内光谱响应的退化幅度比短波范围更大,表明中电池相关电学参数的退化主要来源于基区损伤.     

Investigation of active-region doping on InAs/GaSb long wave infrared detectors

The eight-band κ·p model is used to establish the energy band structure model of the type-II InAs/GaSb superlattice detectors with a cut-off wavelength of 10.5μm,and the best composition of M-structure in this type of device is calculated theoretically.In addition,we have also experimented on the devices designed with the best performance to investigate the effect of the active region p-type doping temperature on the quantum efficiency of the device.The results show that the modest active region doping temperature(Be:760℃)can improve the quantum efficiency of the device with the best performance,while excessive doping(Be:>760℃)is not conducive to improving the photo response.With the best designed structure and an appropriate doping concentration,a maximum quantum efficiency of 45% is achieved with a resistance-area product of 688?·cm^2,corresponding to a maximum detectivity of 7.35×10^11cm·Hz^1/2/W.